[BlueOnyx:00912] Re: Tar.gz installer on Amazon Cloud EC2 + eth0 settings

[Julien Buratto]

Uhm than it's pretty strange.. after the machine starts eecd and services,
the ssh connection drops and from the console interface (I mean a view on
the system logs) I just see that curl is not able to contact an address...
machine is still running but not reachable in any way..

Infact it should be nice to install everything and do not launch new
services (unless confirmed with a prompt) so that SysAd can check network
settings..
Do you know if there is a way to have everything installed without new
services to be started ? should I comment the lines:

## post scripts
/usr/sausalito/constructor/base/wizard/\:sysreset\:linkToWizard.pl

?

Julien

2009/3/31 Michael Stauber <mstauber at blueonyx.it>

> Hi Julien,
>
> > I'm trying to install blueonyx in the Amazon Cloud on a EC2 virtual
> machine
> > via tar.gz installer.
> >
> > As the EC2 are set to have a private network IP address (and then mapped
> > externally with attached public IPs), I need to be able to run the
> > installation without changing the actual IP address which is set on ETH0.
> >
> > What is the best way to achive this ?
>
> The tar.gz installer will not change the network settings, as it's designed
> to
> be run on servers remotely w/o direct physical access.
>
> Of course it's a good and recommended practice to check the network
> settings
> after the install to confirm that they're unchanged.
>
> --
> With best regards
>
> Michael Stauber
>
> _______________________________________________
> Blueonyx mailing list
> Blueonyx at blueonyx.it
> http://www.blueonyx.it/mailman/listinfo/blueonyx
>



-- 
Julien Buratto
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.blueonyx.it/pipermail/blueonyx/attachments/20090331/51302a3c/attachment.html>