[BlueOnyx:10555] Re: Kickstart error during install of BlueOnyx 5108R

[Herb Rubin]

All,

This is a R210 poweredge. I will boot into rescue mode and see what it detects
with ifconfig -a

Herb


----- Original Message -----
From: "Michael Stauber" <mstauber at blueonyx.it>
To: "BlueOnyx General Mailing List" <blueonyx at mail.blueonyx.it>
Sent: Sunday, May 13, 2012 5:57:24 AM
Subject: [BlueOnyx:10553] Re: Kickstart error during install of BlueOnyx	5108R

Hi Bob,

> I had a Dell system with the same issue.  Would like to find a resolution to
> this. I disabled the internal interface and installed a PCI nic card with
> no success.

Even then the question remails which NICs the OS sees. For that please boot 
from the BlueOnyx CD in rescue mode (at the BlueOnyx splash screen type: 
"linux rescue").

When the rescue OS has loaded, type "ifconfig -a" to see all interfaces, 
including the non active ones.

Under Linux eth0 is the defacto standard device for the first network 
interface.

Hence BlueOnyx requires eth0 in various places. In the Kickstart scripts of 
the CD, in the setup scripts at the end of the install and in the base-network 
module of the GUI.

-- 
With best regards

Michael Stauber
_______________________________________________
Blueonyx mailing list
Blueonyx at mail.blueonyx.it
http://mail.blueonyx.it/mailman/listinfo/blueonyx

-- 

Herb Rubin 
Pathfinders Software 
http://www.pfinders.com