[BlueOnyx:18931] New 5208, interface problems

[Jeff Folk]

I don’t know why I have such problems with network interfaces… Grrrr

4th time installing 5208 on this box (Dell XPS 8300, with Realtek PCIe second NIC).

At the end of the install, I log into the command console, am prompted for IP settings, but just eth0. When I get to the GUI to finish setup, there is no eth1. The PCIe add-in card is eth0, built in Broadcom interface is not enabled. Both interfaces were plugged into a switch during install and configuration.

What the heck am I doing wrong? 

Thanks,
Jeff