I've had various problems loading BlueOynx on my SunFire X2200m2 server.<br><br>1) I have two 500GB SATA drives installed. The installer boots and then I get some<br>sort of error and the Install complains about not finding an install disk. I tried a couple times with<br>
the same results. I removed the second disk and then I'm able to get through the install just fine.<br><br>2) The Sun Fire X2200 M2 Server uses 2 Ethernet controllers, the Broadcom BCM5715C <br>chip and an on board NVIDIA nForce
Professional 3600 chip. eth0/eth1 are the Broadcom. eth1 is used<br>for net Mgmt (eLOM and/or IPMI). eth2/eth3  are nVidia gig ports. After I install all is well. <br>I run the yum update and then after a reboot I lose eth0. 'ethtool eth0' reports:<br>
<br clear="all">Cannot get device settings: No such device<br>Cannot get wake-on-lan settings: No such device<br>Cannot get message level: No such device<br>Cannot get link status: No such device<br>No data available<br><br>
/etc/modprobe.conf:<br>alias eth0 tg3<br>alias eth1 tg3<br>alias eth2 forcedeth<br>alias eth3 forcedeth<br>alias scsi_hostadapter sata_nv<br>alias net-pf-10 off<br><br>Anybody got any ideas? I can provide more detail if needed.<br>
<br>Thanks.<br><br>-- <br>-------------------------------<br>Don Caprio <a href="mailto:caprio@uxpro.com">caprio@uxpro.com</a><br><a href="http://www.uxpro.com">http://www.uxpro.com</a><br>(925) 240-UNIX<br>