<div dir="ltr">Did the hard drives come with the server? It sounds like you have caddys from a 1950 that have the tab on them.<div>are the drives fully seated? You may want to take the top cover off to check and make sure.</div>
</div><div class="gmail_extra"><br><br><div class="gmail_quote">On Thu, Jul 25, 2013 at 5:49 AM,  <span dir="ltr"><<a href="mailto:gen@ercuk.com" target="_blank">gen@ercuk.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
<u></u>





<div bgcolor="#ffffff"><font color="#000080" face="Verdana">
<div>Help...I have problems !</div>
<div> </div>
<div>1: The server arrived and I looked it over, and it seemed OK, 
except:<br>...both the 2 HDD-Caddies didn't seem to be pushed all the way into 
their server slots.</div>
<div> </div>
<div>...I found that each drive-caddy was being held slightly forward of their 
fully home position, by little metal tabs that were locating in the grove on the 
right-hand-side of each drive-caddy.</div>
<div> </div>
<div>2: These tabs are each held in position on the face of the server, by 2 
tork-screws, so to release the tabs: I removed the screws, and slid the 
HDD-Caddies out of their slots.<br>I checked them over, and they looked ok, so I 
pushed them all the way into their slots.</div>
<div> </div>
<div>3: I installed the CD-Rom-drive, without any problem.<br>...(this involved 
removing the large top cover, so I also looked around inside to see if there was 
anything obviously loose, and all seemed ok)</div>
<div> </div>
<div>4: I connected a power lead to PSU1, + a monitor, and keyboard.</div>
<div> </div>
<div>5: I plugged in: And the sound of the (4) fans could be heard.</div>
<div> </div>
<div>6: I switched on the server: And it sounded like Concord taking off, as all 
4 fans seemed to be running at maximum speed !</div>
<div> </div>
<div>7: Dells OS booted up, and I pressed F2 to display the 'Main System Set-up 
Program Screen'</div>
<div> </div>
<div>8: I clicked enter, in the menu, at: Boot Sequence</div>
<div> </div>
<div>...the 1st item listed was the: Floppy disk drive<br>...the 2nd item listed 
was the: CD-Rom drive  (ie the new drive I'd just installed)</div>
<div> </div>
<div>...so I changed this around so that the 1st item listed was the now the: 
CD-Rom drive</div>
<div> </div>
<div>...(No HDD's were listed here !)</div>
<div> </div>
<div>9: Now according to the Dell-guide that I have, the next item listed in the 
menu should be: HDD Sequence<br>...but this was not listed, and it isn't listed 
anywhere else in this menu.</div>
<div> </div>
<div>10: I inserted the BlueOnyx install disk: 64-bit install: 
BlueOnyx-5108R-CentOS-6.3<br>...and exited the Dell-Set-up-Screen.</div>
<div> </div>
<div>11: System rebooted and started to run BlueOnyx, and a light-blue screen 
appeared, completely blank except for some very small navigation-text at the 
very top & bottom of the screen.</div>
<div> </div>
<div>...I did what it said to go to the next screen, can't remember exactly 
what.</div>
<div> </div>
<div>12: New screen appeared, with a small box in the centre, asking me if I 
wanted to continue with install, or exit.<br>...I clicked: install</div>
<div> </div>
<div>13: New box said: No HDD detected.</div>
<div> </div>
<div>14: I exited install and switched off server.</div>
<div> </div>
<div>15: Throughout: </div>
<div>a: The green power light was on, and...</div>
<div>b: The 'amber system status indicator' (to the left of the right-hand HDD) 
was flashing.</div>
<div>c: And both continued to flash when the server was powered down.</div>
<div> </div>
<div>Heeelp Pleeese !</div>
<div> </div>
<div>Thanks Mac.</div>
<div> </div>
<div><br></div></font> </div>
<br>_______________________________________________<br>
Blueonyx mailing list<br>
<a href="mailto:Blueonyx@mail.blueonyx.it">Blueonyx@mail.blueonyx.it</a><br>
<a href="http://mail.blueonyx.it/mailman/listinfo/blueonyx" target="_blank">http://mail.blueonyx.it/mailman/listinfo/blueonyx</a><br>
<br></blockquote></div><br></div>