[BlueOnyx:01504] Re: HP DL380 G3

Darrell D. Mobley dmobley at uhostme.com
Thu Jun 25 09:15:08 PET 2009


> -----Original Message-----
> From: blueonyx-bounces at blueonyx.it [mailto:blueonyx-bounces at blueonyx.it]
> On Behalf Of Michael Stauber
> Sent: Thursday, June 25, 2009 1:36 AM
> To: BlueOnyx General Mailing List
> Subject: [BlueOnyx:01499] Re: HP DL380 G3
> 
> Hi all,
> 
> Yes, the PAE kernel runs fine on BlueOnyx. Just install it as Robert said.
> 
> Afterwards check /boot/grub/grub.conf
> 
> In it you will find a line that starts with "default=" followed by a
> number.
> That number there defines which kernel is uses by default on startup.
> 
> PLEASE NOTE: The counting starts with zero, so if the 1st kernel is the
> default kernel then the number should be 0 and your line should read:
> 
> default=0
> 
> Further below you find all the kernels that are installed on your system.
> 
> Check which one is the PAE kernel. If the PAE kernel is the 2nd kernel,
> then
> change the "default=" line to this:
> 
> default=1
> 
> Then reboot the box and it should boot with the PAE kernel by default.

Excellent, I thank you.  I ordered the 6GB of RAM and will report the
install.




More information about the Blueonyx mailing list