[BlueOnyx:17737] Re: new server setup

[Tom]

Michael Stauber <mstauber at ...> writes:

> 
> Hi Tom,
> 
> > I followed your instructions and after running /sbin/ifconfig, 
configuring 
> > correctly and checking with /sbin/ifconfig, everything shows correct. 
But the GUI still shows the old IP addresses of 96.254.220.53, and I get 
the Active Monitor error "The network interface eth0:0 is down.".

[root at ns ~]# /sbin/ifconfig
eth0      Link encap:Ethernet  HWaddr 00:24:E8:50:B2:62
          inet addr:96.254.220.51  Bcast:96.254.220.255  Mask:255.255.255.0
          inet6 addr: fe80::224:e8ff:fe50:b262/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:190 errors:0 dropped:0 overruns:0 frame:0
          TX packets:208 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:16623 (16.2 KiB)  TX bytes:103980 (101.5 KiB)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:271 errors:0 dropped:0 overruns:0 frame:0
          TX packets:271 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:42522 (41.5 KiB)  TX bytes:42522 (41.5 KiB)